Processing of stainless steel structural parts
The processing of stainless steel structural parts is divided into the following points：
1.The out of roundness of hot processed turning (grinding) bar shall not be greater than half of its dimensional tolerance。
2.The indefinite length of processed bar is 300mm-6000mm, and the length of annealed bar is 300mm-2000mm. The length of fixed length or multiple length should be in the range of indefinite length. The allowable deviation of fixed length is + 20mm. The length of double length shall be included in the cutting amount of bar, and the length of each opening shall be 5mm. The length of fixed length or multiple length shall be specified in the contract。
3.Both ends of the bar shall be sawed flush, and the cutting angle of the bar with diameter or side length not greater than 35mm shall not be greater than 3mm. When the diameter or side length is greater than 35mm, the cutting angle of bar shall not be greater than 5mm。
4，Some titanium alloy screws have different hardness, so titanium alloy screws must use good materials, titanium alloy screws have the same hardness as steelSome titanium alloy screws have different hardness, so titanium alloy screws must use good materials, titanium alloy screws have the same hardness as steel。
5，When we use titanium rod in our life, there are many places. However, the understanding of titanium rod is the absolute principle. Otherwise, it will be counterproductive to choose inferior products. Customized stainless steel structural parts processing to provide solutions, so you should look for titanium bar manufacturers to choose goods. For parts like screws, which have to withstand high strength, then I suggest not to use aluminum, which is easy to take off wire, and use titanium rod steadfastly。
